OPERATING INSTRUCTIONS
9
EN
OPERATING INSTRUCTIONS
ON/OFF SWITCHES
–
The hedge trimmer has a lock-out button and
switch trigger.
–
Slide the lock-out button (1) into the handle and
hold.
–
Squeeze the trigger switch (2). The hedge trimmer
will turn ON.
–
Release the lock-out button. The hedge trimmer will
stay on as long as the trigger switch is engaged.
–
The hedge trimmer will stop if you release the
trigger handle.
IMPORTANT:
If the hedge trimmer is accidentally
dropped, the hedge trimmer will turn OFF and the blade
will coast to a stop after several seconds. The hedge
trimmer will then be locked OFF again.
Cleaning the blade regularly and lubricating it at regular
intervals (e.g. 1 hour per operation) will keep the blade
sharp and make the work more efficient
BATTERY CHARGER
SPECIFICATIONS
Charger: WEP8370BC
Input: 120-240VAC, 50/60Hz
Output: 42VDC. Max.2.2A
Weight: 1.2 lbs (0.55kg)
WARNING
The battery is not shipped/transported fully
charged. Fully charge the battery before first use
to ensure that maximum run time can be achieved.
This lithium-ion battery will not develop a memory
and may be charged at any time.
CHARGING PROCEDURE
LED STATUS
DESCRIPTION
Blinking Green
Charging
Solid Green
Fully charged
Solid Red
Stand by
Blinking Red (fast)
Battery too hot
Blinking Red (slow)
Charging fault
Low voltage charging:
If the battery has been stored with little to no charge for
a long period of time, the charger will go into recovery
mode, which will take more time to fully charge the
battery. This will enhance the life of the battery. Once it
is fully charged, the next charge will return to standard
charging.
A fully discharged battery pack will require the allotted
time as stated in the battery manual. Plug the charger
into an AC power outlet.
Insert the battery -into the charger.
This is a diagnostic charger. The Charger LED Lights will
illuminate in specific order to communicate the current
battery status.
False defect note:
When the battery is inserted into the charger and the
status LED blinks RED, remove the battery from the
charger for 1 minute, then reinsert. If the status LED
blinks GREEN, then the battery is properly charging. If
the status LED is still blinking RED, remove the battery
and unplug the charger for 1 minute. After 1 minute,
plug in the charger and reinsert the battery. If the status
LED blinks GREEN, then the battery is properly charging.
If the status LED is still blinking RED, the battery is
defective and needs to be replaced
CHECKING THE CHARGE
If the battery pack does not charge properly:
2
1
