6
(OPTIONAL) PERMANENT MOUNT
For this option, place the winch Freespool in Disengaged, and spool off enough rope
from the winch drum to insert the steel stiffening plate underneath the winch drum, if it
was not Inserted during winch assembly. To resist the winching loads a minimum of
1/4” (6mm) mounting plate thickness should be used. Be certain that the structure
used for mounting will resist the winching loads. Once mounting and wiring is
complete, the winch rope may be powered back onto the drum.
WARNING
–
WHEN USING THE 2 BOLT MOUNTING OPTION, DO NOT USE
THE FRONT SHACKLE HOLE TO DOUBLE-LINE THE PULL BACK TO THE
WINCH BASEPLATE. IF DOUBLE-LINING WITH THE PULLEY BLOCK, ALWAYS
SECURE THE WINCH HOOK TO A NEARBY STRUCTURE, AND NOT THE WINCH
BASEPLATE.
WIRING DRAWING
WARNING
–
The location of the Switch MUST NOT Interfere with safe
operation of the vehicle and winch. Wiring MUST NOT come in contact with
any moving parts or sharp edges, such as engine, winch drum, wire rope, straps,
suspension, brakes, exhaust or steering.
Using the supplied M10 mounting bolts,
washers, and nuts, tighten the mounting
hardware.
WINCH2GO
2-Hole Mounting
Pattern dimensions
