WARPP INTIG-PULSE series, Руководство по эксплуатации

Страница: 6 / 24

-
６
-
(4) The distance between welder and wall must be more than 20cm,
between welders more than 10cm to ensure enough heat
radiation.
(5)
When using water cooled gun, must be care of not being frozen.
2
．
Requirement of input supply:
(1) Input volt must be standard sine wave, effective value 350 ~
465V,frequency 50Hz/60Hz
(2)
Unbalance degree of three phase volt must be no more than 5%
3. Power supply:
Table1: The size of fuse and breaker in the table are for reference only.
4
．
Installation:
The input power of this series welding machines is three phase
AC 350 ~ 465 V. Operator must use the properly disconnected
switchboard or switch box(not outfitted by our company) which is
equipped air switch or breaker, and make sure to ground the
machine safely and firmly.
Product type IN TIG-315 P IN TIG-400 P
Power supply
3 phase AC380V
Min. capacity Power network 13.8KVA 18.4KVA
Input volt
protection
Fuse 32 A 32 A
Circuit breaker 32 A 32A
Cable size
(cross-section)
Input side 4mm
2
4mm
2
Output side 35mm
2
50mm
2
Earth lead 4mm
2
4mm
2