5 September 2019
All dimensions are in mm
Copyright
4
Due to continued product improvement, Warmington Ind LTD reserves the right to change product specifications without prior notification.
SAFETY CONSIDERATIONS
Your Warmington Traditional Gas fire operates on the principle of dual radiant and convected heat. It is important to observe the following precautions
associated with the heating appliance.
•
Do not cover or restrict the fireplace upper or lower vents in any way as this may result in a build
-
up of hazardous gases within the room.
•
The fire is not intended for the drying of clothing, bedding etc
•
Avoid installing this appliance in high traffic areas, strong draughts or near drapes or furniture
•
The use of an approved fireguard is recommended for the protection of young children
•
Avoid using aerosols when the appliance is operating
•
Avoid anyone leaning against or lying directly in front of the fire while operating
•
Do not place anything objects into or against the gas fire at any stage
•
The fire may release a small amount of smoke on its first start up which may take 1or 2 hours to dissipate. This is part of the curing process so
ensure there is adequate ventilation within the room.
•
Always use a registered gasfitter or electrician for installation and maintenance work.
•
Always use certified gas cylinders that have been tested and are safe to use
•
Never modify your gas appliance or its settings from those specified by the manufacturer
WHAT TO DO IF YOU SMELL GAS
•
Open windows and doors
•
Do not light any gas appliance
•
Do not use any electrical appliance or switches
•
Do not use the telephone in your home
•
Leave the building; shut off the domestic gas supply valve (beside your meter)
•
Call your gas supplier/gasfitter or the fire service for further advice.
GENERAL REQUIREMENTS
FLUED GAS APPLIANCES:
•
All gas fires requiring Warmington Flue Systems shall be installed to the requirements of the current standards and shall be appropriately designed
and constructed to permit safe and effective use. This appliance must be flued to the outside atmosphere. All Warmington fires must be Installed
with a minimum of 3.6m of approved Warmington gas flue and liners.
GAS TYPE:
•
All gas fires shall operate safely on the gas type specified on the appliance and shall comply with the requirements of The Gas Act 1992.
ELECTRICAL REQUIREMENTS:
•
All gas fire appliances installed with mains supplied electrical components for associated use with these appliances, and must comply with The
Electricity Regulations 1993.
ELECTRONIC CONTROL SYSTEMS:
•
Any gas fire appliance installed with manual or programmable electronic control system shall be tested and/or approved by a recognised person or
Authority.
SEISMIC RESTRAINTS:
•
All fires used for domestic and commercial purposes shall be firmly secured (unless defined as portable or mobile) to prevent dislodgement from
their point of fixture or installation during seismic activity. Such restraint must be of a reasonable expectation.
GAS CONNECTION
:
•
A gas certificate must be obtained for the installation and commissioning of this appliance and flue system. Check that the gas type specified on the
data plate is correct for the available supply (LPG or NG). A copper gas supply capable of supplying the correct MJ/h, should be brought into the
rear of the installation cavity through the hole provided. A flare nut is provided on the burner for gas connection to the appliance.
SERIAL NUMBER
Serial number
plate view from
inside face of
firebox.
Serial number
plate location,
on
inside
face
of firebox.
