29 March 2021
Due to continued product improvement, Warmington Ind LTD reserves the right to change product specifications without prior notification.
All Dimension are in mm
14
PROCEDURE FOR THE TEST AND COMISSIONING OF YOUR DECORATIVE FIRE.
Ensure Gas Supply and the Power Supply (caution 240V) to the Unit.
•
Refer to Data Plate on this Specification for settings. The Data Plate is attached to the under carriage of
the Burner .
•
Loosen the Jet Test point and attach manometer (Digital is preferred). The Test Point is on the Right Hand
Side of the Gas Burner , as Shown Below .
•
Light Appliance, adjust to High Flame setting and check pressure, adjust to Low Flame and check pressure.
NOTE : If setting the Pressure is required it is to be carried out by a Certified Gas Fitter.
•
If adjustments are necessary, remove the cap . The Pressure Adjustment Screw and Nut are on the Front
Side of the Gas Control Valve (shown in Diagram
B
in this specification) and are
Factory
set.
High Pressure Setting
: Set the Burner to High with the switch. Screw in
Nut A
to Increase the Outlet Pressure
then screw Nut A out to Decrease the Pressure to the desired settings . Use 10mm spanner.
Low Pressure Setting:
Set the Burner to Low with the switch
-
See Wiring Diagram) and, keep Nut A stationary .
Use a screwdriver to screw in
Screw B
to Increase the Pressure and Screw it Out to Decrease the Pressure .
Carefully replace the Modulator Plastic Cap .
WARNING:
To ensure the Correct Operation of the Hi/Low burner it is necessary that the Plastic Cap is returned
to its original location .
