Waring FP2200, Руководство пользователя

Страница: 5 / 13

8 9
Disassembly when removing an accessory disc
• Do not remove the work bowl until the accessory disc is
removed.
• To remove an accessory disc, place your fingers in the two
holes on the blade designated for handling the blade, and lift
the disc. It should remove cleanly.
• Remove the work bowl from the unit by rotating clockwise
to disengage the tabs on the bottom of the bowl platform
from the work bowl. When the bowl handles are positioned
at about the 11 and 5 o’clock positions you can gently lift the
bowl straight up and out.
ASSEMBLY OF CONTINUOUS FEED
CHUTE PARTS
• Clean and sanitize the motor base, and wash, rinse, and
sanitize the continuous feed chute, cover, slinger disc, food
pusher, food pusher insert and processing tools prior to initial
use.
• Place the base on a counter or table near a 3-prong electrical
outlet. Position it so that you are looking at the front of the
unit and can see the control panel. Be certain that the cord is
unplugged and that the controls are in the OFF position (the
red marker will be positioned over the OFF button). Do not
plug in the cord until the processor is completely assembled.
• Pick up the continuous feed chute, holding it in both hands
with the chute pointing in the 4 o’clock position. Place the
chute on the base, fitting its center opening over the motor
shaft.
• Press the chute down so the round lower rim of the chute fits
around the circular platform.
• Place the slinger (or ejector disc) in the bowl, sliding it over
the metal motor shaft until it reaches the bottom of the chute.
• Select the appropriate accessory disc by carefully using the
holes designed for handling the blades or by holding the
processing tool by the non-sharp area of the tool.
• Carefully guide the tool over the metal shaft so that it is
properly seated on the shaft. The disc should easily drop
into place, but if not, gently rotate it until you feel it drop into
place. Do not put any food in the chute before placing the
accessory disc onto the shaft.
• Place the cover on top of the chute with cover locking tab
facing you. Twist the lock so that it holds the cover in place.
• Rotate the entire chute counterclockwise until it clicks into
place and engages the rear interlock.
• The interlock tab on the cover will slide into the interlock
slot on the cover and engage the magnetic safety interlock
switch. The interlock switch prevents operation of the
machine unless the cover is in the proper position. With this
switch engaged, the food processor will operate if the power
is on and the controls are turned to ON or PULSE.
NEVER ATTEMPT TO START THE FOOD PROCESSOR
WITHOUT THE CHUTE AND COVER LOCKED
INTO POSITION.
Two Pushers for Feed Tube
Pick up the large food pusher and the small food pusher. The
large pusher is for processing larger vegetables.
The smaller pusher nests in the larger pusher and can be used for
smaller vegetables, guiding long thin vegetables for more precise
cuts and for jobs like slicing pepperoni.
DISASSEMBLY OF CONTINUOUS FEED CHUTE PARTS–
ALWAYS UNPLUG THE CORD BEFORE
DISASSEMBLING.
• Turn the cover clockwise until the safety interlock tab on the
cover is disengaged from the safety interlock switch on the
chute, and the tabs are clear of the tabs on the cover.
• When the chute is in the 4 o’clock position, you can remove
the cover by twisting the locking mechanism so that it is
horizontal. Next you may remove the cover of the chute.
• Remove the large food pusher from the feed tube. Remove
the small pusher from the large pusher by rotating it
counterclockwise.
• To remove an accessory disc from the continuous feed
chute, place fingers in each hole designated for handling the