waratah HTH623C, Руководство оператора

Страница: 20 / 96

Safety: Maintenance Precautions
T7M7G6M,000042A -19-02JUN20-1/1
T7M7G6M,000042B -19-02JUN20-1/1
Make Welding Repairs Safely
IMPORTANT: Disable electrical power before welding.
Separate harness connectors from the engine
and vehicle microprocessors.
Avoid welding or heating near pressurised fluid lines.
Flammable spray may eject and cause severe burns if
pressurised lines fail as a result of heating. Do not let heat
extend beyond the work area.
Hazardous fumes can be generated when paint is heated
by welding, soldering, or when using a torch.
Remove paint properly. Do not inhale paint dust or fumes.
•
Remove paint a minimum of 100 mm (4”) from the area
affected by heating. If paint cannot be removed, use an
approved respirator before heating and/or welding.
•
If you sand or grind paint, avoid breathing the dust;
wear an approved respirator.
•
If you use solvent or paint stripper, remove the stripper
with soap and water before welding. Remove solvent or
paint stripper containers and other flammable material
from the area. Allow fumes to disperse at least 15
minutes before welding or heating.
Do not use a chlorinated solvent in areas where welding
will take place.
Dispose of paint and solvent properly.
Use a qualified welding technician for structural repairs.
Ensure there is good ventilation, and wear eye protection
and other protective equipment when welding.
T133547
—UN—15APR13
TS220
—UN—15APR13
Keep the welder ground clamp as close to the welded
area as possible to prevent welding current travelling
through the electrical system.
Avoid High-pressure Fluids
This machine uses a high-pressure hydraulic system.
Escaping oil under pressure can penetrate the skin,
resulting in serious injury.
Never search for leaks with your hands: use a piece
of cardboard to find the location of escaping oil. Stop the
engine and relieve pressure before disconnecting lines or
working on the hydraulic system.
Avoid the hazard by relieving pressure before
disconnecting hydraulic or other lines. Tighten all
connections before applying pressure.
If hydraulic oil penetrates your skin, see a doctor
immediately. Injected oil must be removed surgically
within hours or gangrene may result.
Contact a knowledgeable medical source or the Deere &
Company Medical Department in Moline, Illinois, U.S.A.
T133509
—UN—15APR13
T133840
—UN—20SEP00
1-3-8 053122
PN=20