waratah HTH618C, Руководство оператора

Страница: 37 / 92

Operation: Processing
T7M7G6M,00004AF -19-15JUN20-1/1
AM24480,000006C -19-05JUL19-1/1
T7M7G6M,00004B0 -19-15JUN20-1/1
General
IMPORTANT: Do not process toward the cab.
1. Once the tree has been delimbed, it is ready to be
cross-cut into desired products.
2. Depending on log size when cross-cutting, it may be
necessary to support the large end.
3. If multiple log grades are being processed,
pre-planning is important, as this will ensure correct
placement of various grades in order to facilitate the
recovery process.
4. When working on confined landings, ensure safety
procedures and practices are in place and adhered to.
Debarking
1. The process is similar to that above, with the major
difference being the predominant use of debarking
feeding wheels to cut and loosen the bark from stems.
2. The tree is fed back and forth through the harvester
head until the bark is removed. The tree is then
processed.
Measuring
1. Inspect butt of tree and recut if needed.
2. It is advisable to view the measuring wheel while
processing. If during the processing of a tree you
observe the measuring wheel slipping, restart the tree
from the beginning resetting the measuring at the butt.
3. The measuring wheel should be visible when selecting
a log length. Any sudden movements of the harvester
head may cause the wheel to stop or spin.
4. Determine separate stack placement with maybe a
support log for longer logs.
5. Avoid reversing when measuring. Returning to the
end of log and starting again will give more accurate
length measuring.
6. Check diameter and length measuring readouts before
activating the main saw.
7. Calibration checks should be carried out at regular
intervals if measuring equipment is being used.
2-4-1 090721
PN=37