69
Subject to error and alteration
1.3.6.1.4.1.5040.1.2.
44
....
Access the sensors through the following path:
<IP-Adresse>
1.3.6.1.4.1.5040.1.2.X.1.3.1.1.1 = First channel with
a decimal point with comma separation
<IP-Adresse>
1.3.6.1.4.1.5040.1.2.X.1.4.1.1.1 = First channel as
three place integer value, without comma separation
<IP-Adresse>
1.3.6.1.4.1.5040.1.2.X.1.8.1.1.1 = First channel with
one decimal place with decimal point separation
The last index describes the channel number you are querying.
!
For querying indicate the configured SNMP read or read/write
community.
An MIB for incorporating into management applications is
available for downloading on the datasheet page of the device
on the W&T homepage http://www.wut.de or in the device itself
at http://<ip-address>/mib.zip.
If you wish to change device settings via SNMP (IP address,
subnet mask, etc.) you must first start a session on the device
using your SNMP manager.
Entering the administrator password in the variable
wtWebGraphThermoBaroSessCntrlPassword
opens a session. By reading the variable
wtWebGraphThermoBaroSessCntrlConfigMode
you can check whether the session was successfully opened.
1 = Session opened, device is in configuration mode.
