46
W&T
IP-Watcher 2x2 Digital PoE
If authentication is required for the mail server, select the
corresponding procedure for identifying the user:
.
SMTP authentication off: No authentication
.
ESMTP: A user name and password are required for logging
in to the mail server.
.
SMTP after POP3: For an SMTP server it is necessary first to
access using POP3 so that the user can be identified. For
this setting you also specify an associated POP3 server.
Then activate the mail function by checking
Mail enable
.
Apply the changes by clicking on
Temporary Storage
.
On the following configuration page, 2nd Mail, you can set up
an alternate mail account. This alternate onewill be used
automatically, if the first one is not accessable.
„Mail enable“ on the configuration page „Mail“ must be
1
checked to activate 2nd Mail.
4.4.2 Mail parameters and texts
Finally you need to define the alarm messages and the alarm-
specific mail parameters. To do this open the page
Config >> Device >> Alarm >> Alarm X >> Mail
In the field
E-Mail-Addr
enter the address of the recipient. If you
are sending the e-mail to multiple recipients, separate the
addresses from each other with a semicolon.
Finally, configure the required message texts as described in
the section
Formulating message texts
and apply the changes
by clicking on
Save
.
4.5 Alarming per SNMP trap
Open the profile
SNMP incl.alarm via trap
.
