18
3.2 Anzünden
Die Leistungsregulierung wird unter Beachtung der Brennstoffart je nach Zugstärke und
gewünschter Heizleistung eingestellt. Mit Scheitholz insbesondere mit Weichholz, ist nur
ein eingeschränkter Dauerbrand möglich. Braunkohlebriketts sind für den Dauerbrand über
Nacht besonders geeignet, wenn sie auf eine satte Grundglut aufgelegt werden.
Erstes Anheizen / Betrieb
Vor
Inbetriebnahme
sind die evtl. Transportsicherungen auf der Umlenkplatte über
dem Feuerraum herauszunehmen und evtl.
Aufkleber
auf der Sichtscheibe rück-
standsfrei zu
entfernen
.
Öffnen Sie die Heiztür durch Heben des Griffes nach oben. Bei heißem Gerät ist dazu ein
isolierter Schutzhandschuh zu benutzen. Stellen Sie den Primärluft- und Sekundärluftregler
entsprechend der
Tabelle 2
„Verbrennungslufteinstellung“ ein. Öffnen Sie die
Anheizklappe. Legen Sie kleineres Anzündholz, kreuzgeschlichtet auf den freien Rost. Mit
einen Kohleanzünder oder etwas Holzwolle von oben anzünden und Heiztür wieder ver-
schließen. Wenn das Feuer lebhaft brennt warten, bis eine Grundglut vorhanden ist, dann
erneut Brennstoff in geringen Mengen aufgeben, bis eine satte Grundglut vorhanden ist.
Die max. Brennstoffmengen sind zu beachten.
Das erste Anheizen sollte „sanft” verlaufen, mit geringer Menge Brennmaterial, damit sich
die Ofenteile an die Hitze gewöhnen können. Beim ersten Anheizen könnte es zu Rauch-
entwicklung und Geruchsbelästigung kommen. Unbedingt für gute Raumbelüftung sorgen
(Fenster und Türen öffnen) und mindestens eine Stunde auf die max. Nennwärmeleistung
heizen. Sollte beim ersten Heizvorgang die max. Temperatur nicht erreicht werden, so
können die Geruchsbelästigungen auch später nochmals auftreten.
Den Brennstoff nicht in den Brennraum einwerfen, sondern einlegen, da sonst die Aus-
mauerung beschädigt werden kann.
Der Herd darf nur mit geschlossener Fülltür (Heiztür) betrieben werden.
Diese darf nur zum Anheizen, Nachlegen oder Reinigen des Feuerraums geöffnet werden.
ACHTUNG:
Beim Öffnen der Heiztür kann es bei Fehlbedienung oder bei nicht ausreichendem
Schornsteinzug zu Rauchaustritt kommen. Es ist unbedingt zu beachten, dass die
Heiztür nur langsam, zuerst einen Spalt und nach ein paar Sekunden ganz geöffnet
werden darf. Außerdem soll vor dem Öffnen der Tür zum Nachlegen von Brennstoff
nur noch das Glutbett im Brennraum vorhanden sein, das heißt, es dürfen keine
Flammen mehr sichtbar sein.
3.3 Kochen
und
Heizen
Wenn der Herd zum Kochen oder Heizen benutzt wird, ist die Anheizklappe nach der An-
zündphase zu schließen.
Für ein optimales Kochen auf der Herdplatte empfiehlt es sich, nur Töpfe mit flachem Bo-
den zu benutzen. Die wärmste Zone befindet sich in der Mitte der Platte über der Feuer-
rung, die zugleich die beste Zone ist, um einen Topf rasch aufzuwärmen. Die äußeren
Zonen der Platte dienen zum Warmhalten. Um ein schnelleres Ankochen (Kochen) zu
erreichen, empfehlen wir die Verwendung von dünn geschnittenem Weichholz.
Die Herdplatte sollte nicht überheizt werden, weil der Herd dadurch beschädigt, aber kein
Vorteil beim Kochen erzielt wird.
Содержание W3-90
Страница 14: ...14 ...