6.0 INFORMATION REGARDING USE
LBC
2
VAL.LBC.--.M.A2.1219.EN Issue: A2
12.19
45
6.6 Disabling - shutting - down the device at the end of the shift
To disable the device at the end of the work cycle follow the previsions below:
- Cut off the power by disabling the disconnecting switch and positioning the lever on "0" or on OFF.
Important
In case of serious or unknown abnormalities, shut down the device by immediately pushing the mush
-
room-shaped emergency red button placed on the control board and wait for the technicians in charge
to intervene.
Alternatively, demand the support of the Technical Customer Service of the Manufacturer.
6.5 Clearing the Lump Breaking Feeder Valve after clogging
If, during normal operation, the Lump Breaking Feeder Valve actuator is found to be moving gradually under
force and then comes to a complete stop, it is highly probable that the problem is caused by a blockage.
Danger - Warning
The operator assigned must apply rigorously all adjustments regarding safety at the workplace and
take the appropriate measures against industrial accidents.
In particular, do not place your hands into the inlet / outlet spouts close to the Lump Breaking Feeder
Valve if the rotor disc has not been securely locked with external means.
Danger - Warning
Disconnect the Lump Breaking Feeder Valve from all power sources and use suitable means to prevent
it from getting accidentally reconnected.
Follow the indications bellow:
Remove the power supply to the Lump Breaking Feeder Valve:
- Remove the inlet side plant components and make sure that the Lump Breaking Feeder Valve is not ob-
structed by material residues; clean using a tool, if necessary.
Danger - Warning
It is forbidden to enter the hands in the Lump Breaking Feeder Valve.
