Wallenstein CT24, Руководство оператора

Страница: 31 / 48

00192
Fig. 34 –
Recoil Starter
IMPORTANT! Do not allow the starter grip to snap back
against the engine. Return it gently to prevent damage to the
starter.
6. Leave the engine operating at low throttle for a few minutes
to allow it to warm up. Gradually push the choke control
lever open (to the left) as the engine warms.
IMPORTANT! Engine should be warmed up before putting to
work.
7. Once the engine is warmed, increase throttle as required.
Adjust engine speed to preferred conveyor off-load speed.
5.9.7 Stopping Procedure
In an emergency
• Turn the ignition switch OFF.
• Correct fault situation before restarting engine and
resuming work.
Under normal conditions, use the following procedure. Refer to
the engine manual for further information
1. Stop loading material onto the conveyor.
2. Decrease engine speed to MIN .
3. Turn the ignition switch OFF .
5.10 Transporting
5.10.1 Transport Safety
• Comply with provincial / state laws governing safety and
transporting of machinery on public roads.
• Do not exceed a safe travel speed. Slow down for rough
terrain and cornering.
• Do not transport or move the conveyor with the engine
running (if equipped).
• Make sure the conveyor is hitched positively to the towing
vehicle and a retainer is used through the hitch mechanism.
• Inspect wheel rims for dents or damage. Check wheel lug
torque. Refer to table at the back of this manual.
• Inspect tires for cuts or damage. Check tire pressure and
adjust if required. Refer to specification on the tire sidewall.
• Make sure the crank jack is raised and secured with the
lynch pin.
• Clean off all debris from the conveyor.
• Never allow riders on the machine.
• Perform a final circle check before transporting.
1. Clear out all split wood from the conveyor.
2. Shut down the conveyor and the power source. Move the
valve control lever to relieve pressure in the hydraulic lines.
3. Disconnect and cap the pressure and return lines. Place the
hose ends in the conveyor hopper storage holes.
00484
Fig. 35 –
Hose End Storage
• Clean off all dirt, mud, and debris.
• Rotate the crank jack to vertical and secure with the lynch
pin. Raise the conveyor up to connect to the tow vehicle.
Turn the jack back to the storage position once connected.
CT24
Trailer Firewood Conveyor
Operating Instructions
31