Wallenstein CT24, Руководство оператора

Страница: 17 / 48

4. Conveyor Setup
CAUTION!
Park conveyor where wheels are on firm, level
ground. Never raise or move conveyor if wheels
are on uneven ground.
1. Position the conveyor so that split wood from the processor
discharge falls into the conveyor hopper.
2. Block the wheels so conveyor cannot roll in either direction.
3. Unlock the conveyor hitch. Pull out the Hitch Lock Pin and
turn to unlock.
IMPORTANT! Failure to unlock hitch can cause damage as
the conveyor is raised.
00452
Fig. 5 –
Hitch Lock Pin
Fig. 6 –
Decal on hitch plate
4. Anchor the conveyor under the processor discharge by
driving a 1/2" (12 mm) steel rod (not supplied) through the
hole in the hitch into the ground. Anchoring it also holds the
hopper in place if repositioning the conveyor.
01849
Fig. 7 –
Steel Rod through Conveyor Hitch
5. Disconnect the Toplink Pin (if connected) and place it in the
stored position.
01850
Fig. 8 –
Toplink Pin
6. Set the conveyor height as required. Turn winch handle
clockwise to raise it. Counterclockwise lowers it.
00271
Fig. 9 –
Conveyor Winch Handle
CT24
Trailer Firewood Conveyor
Conveyor Setup
17