28
After following all operating safety and preparation procedures the chipper should be set up and ready to
run (4.8). Tractor or Power Pack engine manual should also be reviewed.
4�10 STARTING PROCEDURE
These procedures can be applied to all versions of the BX chipper.
4�10�1 TRACTOR
a. Ensure all the chipper access covers are
secured
b.
Inspect hydraulic connectors for positive
connection.
c. Start tractor.
d. Run the engine for a few minutes to allow it to
warm.
e.
Engage the PTO, then increase engine speed
to approximately half throttle.
f.
Ensure machine is stable, with no unusual
vibration and proceed with work.
4�10�2 STOPPING:
a. Stop feeding material into the hopper.
b.
Place the feed control bar in neutral position.
c. Slow engine RPM.
d. Place tractor hydraulic lever in OFF position.
e.
Disengage PTO.
f.
Stop engine, remove ignition key and place in
your pocket and wait for all moving parts to stop.
4�10�3 EMERGENCY STOPPING:
If an emergency occurs:
• Activate the emergency PTO shutoff on the
tractor (if available) or
• Disengage the PTO
• Shut off the engine
• Correct emergency situation before
restarting engine and resuming work�
Caution:
Be aware that the rotor
will continue to turn for a few
minutes after the PTO has been
disengaged. Wait for all parts to stop
moving before attempting to access the
machine in any way.
