![background image](http://html2.mh-extra.com/html/wallas/26cc/26cc_installation-manual_3236326052.webp)
Device use
Normal use
Temperature is controlled by the thermostat (recommended use).
The device starts when the power switch (3) is pressed in continuously for at least
2 seconds, after which the yellow current indicator light (4) lights to indicate that the
power is on.
The red combustion indicator light will be lit, when the burner flame has been
ignited and combustion has stabilised after ca. 2.5-4 min from when the heater was
turned on.
After the heater has been turned on, you can adjust the thermostat setting using
the temperature control knob (2). Turn the knob to set the temperature to your
desired setting.
When the thermostat indicator light (5) is lit, the temperature in the space to be
heated is lower than the requested temperature and the device is increasing the
power. When the indicator (5) goes out, the requested temperature has been
reached.
The sun-switch shuts down the device automatically, if the temperature rises above
the requested temperature, for example, due to sunlight. The temperature must
rise by +3 °C above the set value for a half an hour. If the device has been shut
down by the sun-switch, an indicator light (5) blinks on the thermostat. The sun-
switch can be turned off temporarily, by turning the temperature control (2).
A device that has been shut down can be restarted manually, if necessary.
Conservation temperature: the temperature control (2) is set to minimum, and the
room is maintained at a temperature of +2–+8 °C. The sun-switch is not enabled in
this mode.
Alternative use
The power is adjusted manually.
To enable this function, turn the power adjuster (2) to positions min - max - min
- max within 10 seconds of the yellow indicator (4) lighting up, during the device
start-up.
The device signals that the function has been activated by blinking the thermostat
indicator light (5) three times.
You can check whether or not the function is in use by turning the power adjuster
(2): the thermostat indicator light should not light up at any point.
1.
Combustion indicator
2.
Temperature adjustment / Power
control
3.
Power switch
4.
Current indicator
5.
Thermostat indicator
6.
Thermostat sensor
Operation
Colour
Blink interval
Function
Yellow
Red
Red
Power on
Combustion indicator when the com-
bustion has begun normally
Aftercooling
Thermostat control
Orange
Orange
Manual power control engaged
Device in remote control mode
Sun switch has shut down the device
Orange
Orange
Device in remote control mode
Orange
en
Signal lights
26CC / 40CC
D80151
- 52 -
3
1
2
10 s
30 s
10 s
10 s
10 s
10 s
10 s
10 s
10 s
1
2
5
6
3
4
M40_M26.indd 1
19.06.2008 14:47:49
1.
2.
3.
4.
5.
6.
490525C
Содержание 26CC
Страница 12: ...12 D80150 Tekniset tiedot Toimintaperiaate fi 26CC 40CC P 12 V 490525C...
Страница 40: ...Technical information Operating principles en 26CC 40CC D80151 40 P 12 V 490525C...
Страница 68: ...Teknisk information Driftsprinciper sv 26CC 40CC D80152 68 P 12 V 490525C...
Страница 96: ...Teknisk informasjon Driftsprinsipper no 26CC 40CC D80158 96 P 12 V 490525C...