7
(888) 253-0777
Length
The knobs that are located on the knuckle hold the struts and side
extenders in place. Measure your pet from hip to shoulder blade.
Make that measurement match the measurement from the center of
the knuckle to the front end of each side extender, as shown below.
L
W
Note: The knuckle should be at the center of your pet's hip. The front
of the extender should be at shoulder blade. You should have a few
inches in back of the rump for elimination (pee and poop).
Adjust to your
pet's measurement.
Measure your pet from
hip to shoulder blade.
Width
To set the width of the wheelchair frame to
the correct size, measure your pet’s chest,
and then add an inch to this measurement;
the width of the wheelchair frame should
be set to this size.
If the width needs to be adjusted, unscrew
the rear knobs counterclockwise until the
back connector comes off , being careful
not to lose the small washers that are inside the knobs.
Line up the back connector with whichever holes will give you
the width measurement you need. Make sure the back connector is
installed on the outside (behind) the wheelchair frame.
Screw the knobs onto the outside of the back connector, making
sure to put each washer in between the knob and the back connector.
Tighten the knobs.
