32
33
6. Preparing the device for use
6.1 Mounting on a lamp stand / ceiling mount
• Check the tightening torque of the fastening screws for the tilt angle setting of the mount (6)
and tighten them if necessary.
• Loosen the fastening screw of the lamp holder (9) until the mount can be inserted into the
attachment adapter of a suitable lamp stand / ceiling mount.
• Attach the yoke holder of the lamp (7) to the attachment adapter of a suitable lamp tripod/ cei-
ling mount. Usually a 5/8-inch (16-mm spigot) attachment adapter is integrated into the lamp
stand / ceiling mount.
• Tighten the mounting screw of the lamp holder (9) again.
• Check once more that the lamp holder and all attachment mechanisms are securely in place.
• As an additional security measure, especially when fastening on a ceiling mount, we recom-
mend using additional stainless-steel safety cables.
• Set the desired tilt angle.
• The LED light is now mounted and ready for use.
6.2 Mounting the diffuser and barndoors
Mounting the diffuser and especially barndoors is easier if the lamp is removed from the lamp
stand and the lamp, including the mount with the LED ligth, is placed upwards on a table.
• Slide the unlocking mechanism for the diffuser and barndoors (13) on the backside of the
lamp outwards, and at the same time, press the locking mechanism for the diffuser and
barndoors (5) towards the lamp (downwards).
• The diffuser and / or the barndoors with the mount/holding frame can now be inserted into the
device.
• If necessary, slide the diffuser into the LOWER guide rail.
• If necessary, slide the frame of the barndoors into the UPPER guide rail.
• Place both in the centre (when doing so, pay attention to the notches in the diffuser) and
ensure that the flaps are not inserted at an angle.
• Pull the locking mechanism for the diffuser and barndoors (5) with your fingers out of the de
-
vice (upwards). Ensure that the locks have been pulled out completely out of the device until
they hit the stopper.
• Then check that the diffuser and / or barndoors are firmly in place.
• The LED light is ready for use and can be mounted again on a stand.
• To disassemble the diffuser and the flaps, do the same in reverse order.
NOTE
When closing the 4 light flaps, first of all close the smaller light flaps on the side and then the
long flaps at the top and bottom.
NOTE
Please follow the user information issued by the stand manufacturer.
WARNING
Only mount the device on a stand that has been designed for the weight and
dimensions of the device.
See technical specifications.
Make sure that the stand with the mounted device is safe against tipping over or slipping.
9
13
5
5
