500.0001-D
9
Technical alterations reserved
2.4.
Assembly, interior construction
After anchoring the safe, its chrome-steel interior construction (lid, side walls, base, and
rear wall) has to be completely assembled again. It is important to assemble the individual
metal plates with care so as to avoid scratching them.
PLEASE NOTE:
The following procedure describes how to assemble the interior of
a WALDIS Business safe. If you have a WALDIS Eco safe, you can follow the same
procedure and neglect the rear wall and the lid!
1.
Allow the rear wall to tilt forwards
from the top and then turn it
diagonally onto one side. Then, lift
the rear wall and carefully push it
into the safe.
Push the rear wall evenly backwards
towards the interior rear wall of the
safe.
2.
Push the base into the safe
diagonally and carefully set it down
on the interior floor while holding
back the rear wall.
Caution: Make sure that no wires
get caught when setting the base
down!
3.
Guide the right-hand side wall into
the safe diagonally and plug it into
the plug connection in the base. As
soon as the side wall is plugged into
the base, it can be stood upright on
the right-hand side and screwed in
(4mm Allen key) at the centre of the
safe using the cylinder screw.
Caution: Only screw in lightly!
