500.0001-D
8
Technical alterations reserved
2.3.4.
Procedure
The safe is delivered with 4x cylinder screws with an M12x30 internal hex (DIN 912,
strength grade 8.8), 4x M12 washers (DIN 125 A) and 4x M12x50 drop-in anchors.
If it is not possible to use the installation material specified or it is not possible to anchor
the safe, please consult your property insurance provider to find an alternative anchoring
solution.
Follow this procedure to anchor the safe into the building wall or floor:
1.
Draw the drilling pattern on the desired position and then drill the anchoring holes with
Ø15 concrete drill and an impact drill.
➔
The Ø15 drill hole must be at least 54 mm (from the wall/floor) or at least 108 mm
(from the safe’s
interior wall) deep.
2.
The EA2 M12x50 drop-in anchor can be hammered in once all four anchoring holes
have been drilled.
➔
Please consult the manufacturer’s information sheet for hammering in the Fischer
EA2 M12x50 drop-in anchor (Fischer no.: 48406).
3.
Align the safe with the installation holes in the building wall or the building floor.
4.
If the safe is to be anchored to the building wall, it has to be evenly hammered into the
wall evenly.
5.
Level out the safe so that the door stands still in any position and does not start to
swing in one direction (open or closed) on its own.
➔
To do this, place small hardboards (Pavatex) under the corners required.
6.
Attach a washer to each of the cylinder screws and screw them through the anchoring
sleeve into the drop-in anchor (10mm Allen key) until they line up.
7.
Tighten the cylinder screws to 35 Nm (10mm Allen key), and then tighten them again
to 35 Nm in the same order to be sure.
If the installation material supplied cannot be used owing to the quality of the floor or wall,
installation has to be adapted to the actual conditions. The dowel used must match the
type of quality of the building material to be anchored into (minimum requirements for
threaded rods, screws and dowels M12: Strength grade 8.8, DIN 975 with ISO 7089
discs). Please observe the manufacturer’s instructions.
Safe wall
Anchoring sleeve
Cylinder-head screw
with washer
Building wall /
Building floor
Drop-in anchor
