Wahl MAX 45, Инструкция по эксплуатации

Страница: 16 / 36

16
Description of parts (Fig. 1)
A Blade set
B
Release button for blade set
C
On/off switch (2 speed)
D
Hang-up loop
E
Mains cable
F
Clip for blade set
G
Replaceable drive lever tip
H
Special tool
I Oil bottle
J Cleaning brush
Mains Operation
1. Before starting the appliance, always oil the blade set (Fig. 12).
2. Only connect the appliance to the socket while it is switched off.
3. Connect the mains plug to the socket.
4. Switch on the appliance using the on/off switch (Fig. 1).
5. The appliance is equipped with 2 speed settings. These can be selected via the on/off switch.
Setting 1a = standard speed, setting 1b = high speed.
6. After using the appliance, switch it off and remove the mains plug.
Cutting with the attachment comb
The appliance can also be operated with attachment combs. Attachment combs can be used to extend the
cutting length range. Accessories are available from your dealer.
For best results we recommend using a #30 or #10 blade with the comb attachments.
Accessories are available from your local dealer.
Attaching / removing the attachment combs
1. Fit the attachment comb onto the bottom edge of the blade set (Fig. 2
a
) and push it over the cutting
edge of the bottom blade until it locks (Fig. 2
b
).
2. Push the attachment comb towards the cutting edge of the bottom blade (Fig. 3) and remove it from
the blade set.
Changing the blade set
Replace a blunt or damaged blade set with an original spare part only. Spare parts can be ordered
through your dealer or Customer Services.
Before replacing the blade set, switch the appliance off.
Lubricate the new blade set before attaching (Fig. 12).
Removing the blade set:
1. Press the release button (B) (Fig. 4
a
) towards the blade set and lift the blade set out of the housing
(Fig. 4
b
).
2. Lift the blade set out of its clip (Fig. 5) and ensure that the clip remains folded out.
Attaching the blade set:
1. Attach the new blade set onto the clip (Fig. 8a).
2. Ensure that the clip is folded out. If this is not the case, you can fold out the clip with a flat
screwdriver (Fig. 7).
3. Push the blade towards the machine to snap into place.
4. If the blade fails to engage, switch the appliance on (Fig. 3), then push the blade set against the
hand-held appliance until it audibly clicks into place and the blade moves (Fig. 8b).
Replacing the drive lever tip
The drive lever tip (Fig. 9) is a wearable part. If necessary, it can be replaced in the following manner:
1. Remove blade set (Fig. 4/5).
2. Using the special tool (H) provided, grip the tip and pull off the drive lever (Fig. 10
a
).
3. Fit new tip to drive lever and press down firmly until it engages (Fig. 10
b
). For this task, only use the
special tool (H) provided.
Model: POWER GRIP - CORDED DOG CLIPPER - 8879