Wahl MAX 45, Инструкция по эксплуатации

Страница: 5 / 36

5
USEFUL INFORMATION ABOUT YOUR PRODUCT
Essential information
For maximum efficiency, durability and satisfaction from Wahl clippers and trimmers,
please note the following points:-
•
Regularly apply a few drops of oil to the blades during clipping/trimming. Clipper
oil lubricates the blades and will ensure your clippers or trimmers perform to
their maximum capacity. Without oil, friction is increased therefore generating
heat. If blades are getting hot then insufficient oil is being applied or the blades
need cleaning or sharpening.
•
Always ensure the animal coat is dry, as clean as possible and brushed to
remove tangles, grease and dirt particles from the hair.
•
During operation, take time to regularly brush hairs and dirt from the blades.
•
We recommend use of Wahl Hygienic Spray to ensure grease and dirt particles
are flushed from the blade surface. DO NOT use water to clean the blades.
•
Always oil the blades after cleaning.
•
Always clean your machine and blades thoroughly when you have finished
clipping. Do not separate the top and bottom blade when cleaning.
•
If your product has an air filter ensure it is clear of obstructions to avoid
overheating the motor.
•
Whenever storing your appliance, disconnect all cables and store your clipping/
trimming kit in a dry, temperate environment.
•
Always oil your blades before use and before storage to prevent atmospheric
moisture causing damage to the blade surface.
BLADES
The blades are the single most important part of a clipper or trimmer and must be
well maintained at all times for maximum cutting performance.
Cutting hair does not blunt the blades. Abrasive particles on the animal’s hair, such
as dirt, sand, grease, etc will blunt the blades.
Blades will not cut if abrasive particles are picked up and carried by the oil film
between the blades. These particles tend to separate the blades from each other
and pull the hair as opposed to cutting it cleanly. Keeping your blades well oiled
performs the following important functions:-
•
Provides a low friction, very thin film lubricant between the cutting blades so the
blades can take a full cutting stroke without becoming hot from frictional heat.
•
Flushes abrasive particles and hairs out from between the blades.
If you cut into dirt, immediately clean your blades with Wahl Hygienic Spray or Wahl
Clipper Oil to flush out the dirt. ALWAYS apply clipper oil after cleaning with hygienic
spray or coolant.