54
Parameterizing
WAGO-TO-PASS® 761
761-214 Telecontrol Module Compact, 8 AI, ESP, DSP
Manual
Version 2.0.0
Table 26: Configuring the addresses
Phone/Fax/Mail
Address 1 ...
Address 4
Enter the target addresses in these fields:
Transmission as SMS:
Enter the mobile phone number of the recipient.
Click the button
[T2T]
when the SMS recipient is also a
TO-
PASS
®
telecontrol module, e.g., when alarm messages are to
be used as switching commands in the other
TO-PASS
®
telecontrol module.
Transmission as e-mail:
First, enter the e-mail identifier for the provider of the SIM
card being used. The following identifiers may be used:
-
T-Mobile:
8000
-
VODAFONE:
3400
-
E-Plus
7676245.
Enter a comma (,) after this identifier, followed by the e-mail
address, e.g., for a T-Mobile SIM card:
"8000,[email protected]".
Transmission as fax:
Follow the instructions from the provider for transmissions as
fax messages. For T-Mobile or Vodafone, for example, enter
the identifier "99" directly in front of the fax number:
"99057123456789".
Number
check
In this field enter the number of digits to be used for number
checking. If the entered number is longer than the number of
digits entered in this field the last digits of the number will be
checked.
This function is available starting with Firmware Version FW
2.33.
Address allocation is only possible when
number checking is activated!
Incoming SMS messages cannot be allocated to an
address in the memory when number checking is
not active, meaning, for example, that standby is
not possible. If there are delays in responding when
number checking is not activated, the target
address may be overwritten by a new SMS.
