6
English
1. Slide all parts of the wheel
assembly over the end of the
axle in the order shown.
Make sure the spacer
(a)
is
oriented so the lipped side will
be flush inside the axle slot
(c, at right)
. Lightly tap the
push nut tool with a mallet to
secure the push nut
(b)
over
the end of the axle. Repeat
steps for other wheel.
2. Slide both ends of the axle up into the slots as shown
(c)
.
The lipped side of the spacers
(d)
should go inside of the
axle slots.
Do not plug in the power cord until assembly is complete.
3. Make sure each axle plate is oriented and located as
shown
(L and R)
. Secure each plate with two (2) screws.
Snap the wheel caps
(e)
over the ends of the push nuts.
4. To assemble the handle, press
the button
(f)
as shown and
slide the handle into the cart
assembly.
Once the handle is fully inside
the cart, release the button and
pull the handle until it locks in
up or down position.
5. Thread one end of the high pressure spray hose to the
spray hose port. Tighten with an adjustable wrench.
6. Thread the other end of the hose to the spray gun. Hold
the gun with one adjustable wrench and tighten the hose
nut with the other.
(c)
(d)
LR
(e)
(e)
X 2
b)
a)
(f)
Underside of unit
Rear view
NOTE - You will need to stand the
axle vertically on a flat and stable
surface to assemble the wheels.
Assembly
Inside view
