Wagner Meters Orion 910, Инструкция по эксплуатации

Страница: 8 / 21

11 12
When in the Standard Measurement mode,
pressing and releasing the ON/HOLD
button will freeze whatever reading is
showing on the display. Additionally,
the word HOLD will show in the upper
right-hand corner. This HOLD feature is
valuable when taking measurements in
hard-to-reach places where you cannot see
the display.
If the AUDIO function of the meter is
turned on (refer to the “Audio Button”
section on page 19), the meter will emit a
short beep every 4 seconds that the current
reading remains on HOLD.
The current reading will remain on the
screen until the ON/HOLD button is
briefly pressed again, returning the meter
back to Standard Measurement mode and
HOLD will disappear from view.
NOTE: Meter will shut down automatically
after 60 seconds if the meter is left on HOLD
with no measurement activity. Pressing the
ON/HOLD button for 2 seconds will turn the
meter off.
ON/HOLD Button
When the meter is OFF,
pressing and releasing the
ON/HOLD button will
turn the meter ON, with the meter briefly
displaying the model number, followed by
the firmware revision number. Immediately
after briefly displaying the revision
number, the meter will be in the Standard
Measurement mode. At this point, the meter
is ready to take moisture measurements.
Be assured that any settings that you have
previously programmed/selected will be
active. In other words, turning off the meter
will not cause the meter to revert to factory
default settings, but will retain whatever
settings you programmed it with.
FUNCTION BUTTONS:
DETAILED USAGE INSTRUCTIONS
ACQ, or any other treatment with metallic
or other components that might bias the
moisture readings.