Mounting the LCD monitor
PerfectView M70L
26
z
Check beforehand that there is sufficient room for the drill head to come out on
the other side (fig.
2
, page 4).
z
Bear in mind the weight of the monitor. Provide reinforcement if necessary
(larger washers or plates).
z
Ensure that you can lay the connection cables to the monitor.
To perform the installation, proceed as follows:
➤
Mount the monitor and the mounting rail (fig.
a
1, page 6) onto the monitor
base and secure it with the knurled nut (fig.
b
1, page 7).
➤
Position the monitor and the attached monitor base fortesting.
➤
Mark the outlines of the corners of the monitor base on the dashboard.
➤
Unscrew the monitor base from the monitor.
➤
Hold the monitor base within the outlines marked beforehand and mark three
different drilling points.
➤
At the points marked beforehand, drill holes of
∅
2 mm.
➤
Screw the monitor base on with the 4 x 20 mm self-tapping screws.
➤
Mount the monitor and the mounting rail (fig.
a
1, page 6) onto the monitor
base and secure it with the knurled nut (fig.
b
1, page 7).
6.3
Connecting the monitor to an electricity supply
The circuit diagram for the LCD monitor can be found in fig.
c
, page 7.
No. in
fig.
c
, page 7
Description
1
Monitor
2
13-pin socket
3
Monitor line
4
13-pin plug
5
12–24 V positive cable (red): connection to the positive pole of
the ignition (connected positive, terminal 15)
6
Earth cable (black): connection to the negative pole of the
power source
7
6 pin DIN socket (connection to video source 1)
8
6 pin DIN socket (connection to video source 2)
9
Cable (green): control input for the connection to the reversing
lights (programmable for V1 and V2)
10
Cable (white): control input from indicators for the side-view
camera (video input V2)
_RV-70.book Seite 26 Freitag, 15. Dezember 2006 4:15 16
