Connecting the inverter
PerfectPower
22
The inverter is equipped with protection against thermal and electrical over-
loading, as well as excess and insufficient voltage. The inverter switches off:
z
If its internal temperature is too high
z
If the load exceed the values stated above
z
If the input voltage is too high or too low
The inverter can be switched on and off using the switch directly on the
device or using an external switch.
I
Note
Note when connecting devices with an electrical drive (such as
power drills and refrigerators), that they often need more power
than is stated on the type plate.
6
Connecting the inverter
6.1
Fastening the inverter
You can fasten the inverter using the four holders supplied.
When selecting the installation location, observe the following instructions:
z
The inverter can be mounted horizontally or vertically.
z
The inverter must be installed in a place that is protected from moisture.
z
The inverter may not be installed in the presence of flammable materials.
z
The inverter may not be installed in a dusty environment.
z
The place of installation must be well-ventilated. A ventilation system
must be present for installations in small, enclosed spaces. The clearance
around the inverter must be at least 25 cm (fig.
4
, page 5).
z
The air intake on the underside or the air outlet on the back of the inverter
must remain clear.
z
For ambient temperatures higher than 40 °C (such as in engine or heating
compartments, or direct sunlight), the heat from the inverter under load
can lead to the automatic shut-off of the inverter.
z
The installation surface must be level and sufficiently sturdy.
a
Caution!
Before drilling any holes, ensure that no electrical cables or other
parts of the vehicle can be damaged by drilling, sawing and filing.
_PP150_PP400_PP600.book Seite 22 Donnerstag, 12. November 2009 2:25 14
More information https://www.caravansplus.com.au
