Wadkin Bursgreen WB800H, Руководство пользователя, Страница: 7 / 27

5
SAFETY SYMBOLS USED THROUGHOUT THIS
MANUAL
SAFETY SYMBOLS
Floor Load
When using the saw always ensure the
operator as well as those in the area
wear ear protection.
When using the saw always ensure the
operator as well as those in the area
This machine represents a moderately large
weight load in a small footprint. Most commercial
shop floors will be adequate for the weight of the
machine. Some floors may require additional
support. Contact an architect or structural
engineer if you have any question about the ability
of your floor to handle the weight.
wear eye protection.
To ensure sufficient upright stability of the
machine it should be bolted to floor
.
For this
Some wood and wood composites have
the potential to be highly toxic; always
wear a face mask when operating saw.
purpose 4x12mm diameter holes are provided
in the machine
'
s base plate
.
Working Clearances
Working clearances can be thought of as the
distances between machines and obstacles that
allow safe operation of every machine without
limitation. Consider existing and anticipated
machine needs, size of material to be processed
through each machine, and space for auxiliary
stands and/or work tables. Also consider the
Danger / Caution: Indicates risk of
relative position of each machine to one another
personal injury and/or the possibility of
for efficient material handling. Be sure to allow
damage.
yourself sufficient room to safely run your
machines in any foreseeable operation.
Warning: Risk of electrical injury or
Lighting and Outlets
damage!
Note: Supplementary information.
Drawing-in / trapping hazard! Risk of
personal injury to body parts or clothing
by being drawn into the rotating saw
blades.
Lighting should be bright enough to eliminate
shadow and prevent eye strain. Electrical circuits
should be dedicated or large enough to handle
combined motor amp loads. Outlets should be
located near each machine so power or extension
cords are not obstructing high-traffic areas. Be
sure to observe local electrical codes for proper
installation of new lighting, outlets, or circuits.
Dust Collector
As a rule, this machine must be vacuumed during
SITE CONSIDERATIONS
use. A time relayed socket is available as an
accessory. In addition, the vacuum performance
General Condition:
must be sufficient to achieve the required
1. Electrical connection: Steady state voltage:
0.9-1.1 of nominal voltage.
Frequency: 0.99-1.01 of nominal frequency
continuously; 0.98-1.02 short time
2. Altitude are not exceeding 1000m,
Maximum ambient air temperature is +40
O
C,
minimum ambient air temperature is not less
negative pressures and a maximum air speed of
20m/sec at the connector.
Read the manual before assembly
Than+5
O
C, and operation. Become familiar with
Storage and transportion temperature range is -
15
O
C
～
+55
O
C.
The relative humidity does not exceed 50% at a
maximum temperature of +40
O
C, higher
relative humidity may be permitted at lower
temperature (e.g. 90%@ 20
O
C).
the machine and it's operation before
beginning any work. Serious
personal injury may result if safety
or operational information is not
understood or followed.