Wadkin Bursgreen WB800H, Руководство пользователя, Страница: 13 / 27

11
Loosen the required allen bolt/s.
Move the guide block, guide assembly and/or the
pole until the guide block is set in the correct
position.
Rotate the belt tension handwheel( V ) to adjust the
V-belt tension.
Setting the Mobile Wheel Kit (optional)
Place
“U” Shape Bracket(6) onto Front Wheel
Re-tighten all of the allen bolts to secure the Kit Ass'y (a). The Front wheel Kit Ass'y
guide block in place. Assembled by factory enclosed the parts
1,2,3,15 and 4.
(
refer diagram F
)
Insert Hex Head Screw M10x70(8) with
washer(9), secure Front Wheel Kit(a) and
Lower guide
:
Sleeve(10) to work stand.
Insert Special Thread(14) with washer(1) and
secure Front wheel kit.
Secure Rear Castor Frame(11) to workstand
with two Hex Head Screw M10x20(12) &
washer(7).
When move the machine adjust the Allen Bolt
M12x50(5),and raise the machine about 5mm
above floor. Insert the Rear Castor Ass'y(b),
push the lever down and pull the machine
round the workshop.
Loosen the knurled jam nut(Q)and rotated the
adjusting rod to set the lateral guide block.
The rear guide block is adjustment by the allen
screws (U) & (T).
Allen bolt U - This allows the guide assembly to
be moved and should be utilized when large
movement is required.
Allen bolt T - This allows the rear guide block to
move along the channel on the guide assembly
and should be utilized when only a small amount
of movement is required.
Setting the V-belt tension
The V-belt is accessed via the lower door.
Squeeze the center of the V-belt. Note the amount
of deflection. Defelection shoud be approximately
3/4".
V
S
T
T
U
R
Q