Wadkin Bursgreen WB800H, Руководство пользователя, Страница: 11 / 27

9
Fitting the fence rail
SET UP
To fit the fence rail, firstly check 4 winged screws
Warning
!
Before carrying out any
and washers( I ) supplied into the 4 threaded holes
maintenance or adjustments the
on the bottom of the table.
machine must be disconnected from
the power supply
.
Note: The winged screw only need to be
fitted with a few turns so there is an Setting the table stop
adequate gap to fit the rip fence rail( J ).
Line the cut-outs on the fence guide with the
winged screws earlier fitted to the bottom of the
The positive stop under the table allows you to
repeatedly square up the table after adjusting the
table to another angle.
main table.
To adjust the positive stop:
Push the fence rail forwards against the front edge
1. Loosen the ratchet lever
(
M
)
on the table
of the main table.
trunnion
Fully tighten the winged screws to secure.
2. Loosen the hex nut
(
K
)
on the positive stop bolt
(
L
)
and lower the stop bolt.
3. Raise the upper blade guide assembly and
place a 6" machinist's square on the table
against the blade. Notice how far out of square
your table is and approximate this distance by
adjusting the positive stop up or down. Turning
the positive stop raise or lower it. Adjust the
positive stop so the table will stop at a 90°
angle (square) to the blade.
4. Lock the positive stop by tightening the hex nut.
Do not let the stop turn while tightening the hex
nut. Tighten the ratchet lever
(
M
)
.
5. Set the angle pointer to zero on the table tilt
gauge.
Fitting the rip fence
Fit the profile of the rip-fence carrier into the
opposite profile on the rip-fence rail.
Secure it in the desired position by simply
pressing down on the rip-fence locking handle.
L
K
M