Wacker Neuson PS2A 800, Руководство оператора

Страница: 43 / 58

Prepare for Safe Operation
13
Loading & Transporting Pumps
WARNING! Before loading or unloading any type of
pump, make sure to wear all necessary PPE such as
steel toed boots, gloves, safety glasses and hard hat.
Loading Hauling Pumps
Before unloading and loading hauling pumps, always
refer to the manufacturer’s operating manual for specific
instructions.
When loading and unloading pumps, check for the
following:
• Pump hauled on vehicles MUST be securely tied
down with approved straps or chains
• When loading the pump, place unit as far forward on
the truck bed as possible
• Before hauling the pump in an open-bed truck,
walk around the vehicle to assure all fittings on the
machine are not over-hanging the truck bed
• Any fitting that is not securely attached to the pump
must be removed and secured separately before
transport
• Do not lift, load, relocate or unload pumps when
section or discharge hoses are attached
Loading Wheel Mounted Pumps
• Check your surroundings while pulling up to the
pump with a lift truck
• Stop, lock the brake, turn off the lift, remove the
seatbelt and get off the lift
• If applicable, use appropriate tools to loosen, lower,
tighten or raise the support stands on trailer-mounted
pumps
• Get on the lift truck, fasten the seatbelt, start the lift
truck and disengage the parking brake
• Put the lift in forward and drive the forks under the
pump being careful not to damage the pump, tires,
support legs or anything nearby
• Carefully raise the forks and tilt the pump back
slightly until it is approximately 4”-6” inches off the
ground and carefully transport as needed
• Check the overall height to ensure compliance with
DOT restrictions
Wear necessary PPE
when loading and
unloading
Warn Personnel Before Starting
Before starting, walk completely around the machine.
Make sure no one is on it or close to it . Let others
know you are starting up and don’t start until everyone
is completely clear of the machine. As the equipment
operator, you are responsible for the safe use of the
machine, so always make sure you have communicated
your work plans to others on the site.
Check the pump thoroughly at delivery for any shipping
damage.
Locate the pump in an accessible location, as close to
the liquid as possible.
Secure the pump after it is placed in its intended
operating position so it does not tip, roll, slide or fall.
Starting the Engine
WARNING! Never attempt to start the engine by
shorting across starter terminals. Serious injury or
death may result.
Know the exact starting procedure for your machine.
See the manufacturer’s operating manual(s) for starting.
• Familiarize yourself with warning devices, gauges and
operating controls
• Make sure controls are in the neutral/locked position
• Clear the area of all persons
• Start the engine following the instructions in the
manufacturer’s operating manual(s)
• If necessary to run the engine or operate the machine in
an enclosed area, ensure there is adequate ventilation
WARNING! Exhaust fumes can kill. Do not breathe
exhaust fumes!
Before starting,
walk completely
around pump
Start Safely
14