User manual - DMS9648O
85
12.6 Loading configuration from memory card
To load a configuration previously made and saved on a memory card, connect
it to the micro-USB connector and power the instrument. At this point, if the
memory card is detected and the data it contains are considered valid, the
display will view the request for loading data from the memory card.
Load data
Esc
The user can either “Load data” load the
parameters from the memory card or “Esc”
cancel the operation without modifying the
current configuration.
13
Table complete of configuration parameters
13.1 Analogue input
Parameters to configure the analogue input.
1
Sensor type
Analogue input configuration/sensor selection
Strain-gauge (
Default
)
4 wires (+ 2 optional calibration wires)
Potentiometer
min. 200 Ω
2
mV/V sensor
This parameter sets the ratio mV/V for the chosen strain-gauge. It has no
meaning if a potentiometer is selected as sensor
0,001..20,000 mV/V,
Default
: 2,000 mV/V.
3
Decimal Point
Select type of the visualized decimal point
0
Default
0.00 2 Decimals
0.0 1 Decimal
0.000 3 Decimals