WAC Lighting 5021-CCBBR, Инструкция по установке

Страница: 2 / 22

WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. JAnuAry, 2016 2
waclighting.com
Phone (800) 526.2588
Fax (800) 526.2585
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
INSTALLATION INSTRUCTION
In-Ground Color Changing
5031-CCBBR
1. Turn the main power off.
2.
Install wiring and conduit (use 1/2” NPT) with Concrete Pour
Canister at desired position, plug all un-used holes (Fig. 1)
Secure the canister to the bottom of the application ground
by using screws.
Note: For proper alignment, make sure the flat edge of the
canister is parallel to the wall. (Fig. 2)
3. Insert Plastic Cap into Concrete Pour Canister (Fig. 1)
4.
Pour concrete until it’s flushed with the Plastic Cap. (Fig. 3)
Note: NO CONCRETE ENTERS THE BOX. USE SAND OR
GRAVEL FOR PROPER DRAINAGE.
5.
After concrete has cured, crack concrete and remove Plastic
Cap using a corkscrew or similar tool. (Fig. 4)
6. Connect fixture leads to box wiring using supplied outdoor
rated wire nuts. Make sure all power is off while wiring LED
fixture.
7. Apply a smear of plumber’s silicone to O-rings. Insert LED
fixture into flange with a twisting motion. Make sure the trim
is flushed with the top of the poured concrete.
8.
To match different height requirements, use extenders and
cover plates. (Fig. 5)
CONCRETE POUR INSTALLATION Fig.1 Fig.2
Fig.3
Fig.4
Fig.5
Plastic Cap
Concrete
Sand or pea gravel
(For Drainage)
Sand or pea gravel
(For Drainage)
1/2” NPT pipe extender
(Not Provided)
4” Junction box cover
(Not Provided)
LED Fixture
Outdoor Rated
Wire Nuts
Concrete
O-Rings
Soil
Soil
Concrete Pour
Canister
1/2” NPT
Wall
Parallel