WABECO D2000E, Руководство по эксплуатации

Страница: 27 / 46

27
8. Startup and Maintenance
8.1 Electrical equipment
The lathes are fitted with a master switch with undervoltage release, i.e. this switch must be
switched on before the machine can be switched on via the reserving switch. The master switch
must also be switched on again following a power failure.
RUECKW VORW
0
AUS
NOT
potentiometer
master switch
NOT-AUS
switch right - left
ON - OFF lever
for automatic feed
i
All lathes can only switched on with closed plexiglass bonnet .
If you want to change the turning direction through the switch right-left the switch must stay for 1
sec. on 0-position for the reason that the relay of the potentiometer has enough time to react.
8.2 Start up
i
Prior its putting into operation the machine must once more be cleaned with
great care. All lubricating points have to be furnished with grease while the
cross slide, the threaded spindles, the guide bars and the quill are thoroughly
oiled.
Turn by hand all spindles in order to check for their smooth turning.
Run in the lathe with the lowest possible rotary speed being switched on. A
full load to start with must be avoided!
8.3 Maintenance
The longtime serviceability is vitally dependent upon a corresponding serving attendance. The lathe
needs to be cleaned after every turning job.
i
In case the lathe is being erected within a moist cellar, all naked parts need to
be oiled after completed usage to avoid corrision.
An overall and constant lubrication of all moving parts is highly signeficant.
In case backlash within the bearings or within the guideways of the slides
should occur, readjust in time to avoid the bearing or the guideways of the
slides being destroyed.