Fig. 63
8.
Set the oven to call for heat and measure the Micro Amps reading.
Micro Amp reading from the flame sensor should measure a minimum of 0.7 Micro Amps to maintain burner
ignition.
•
If Micro Amp reading is correct and the burner does not light and maintain flame, replace ignition module.
•
If Micro Amp reading is
NOT
correct, check wiring from flame sensor/igniter to the ignition module. If wiring
is ok, replace flame sensor/igniter.
9.
Install ignition control module mounting bracket and right panel.
10. Verify operation.
SG4 & SG6 Series Full Size Gas Convection Ovens - SERVICE PROCEDURES AND ADJUSTMENTS
F35626 Rev. B (1118)
Page 34 of 56
