Fig. 31
8.
Remove motor mounting plate nuts (1, Fig. 31).
9.
Place a piece of cardboard on bottom of oven
cavity to protect its surface from any damage
during motor assembly removal.
10. Pull motor assembly into oven cavity and place
on cardboard.
11. Remove motor mounting bolts and washers and
lift motor off mounting plate.
Fig. 32
NOTE:
Motor graphics are shown with motor
installed.
12. Remove drip pan from motor and install onto
replacement motor.
Fig. 33
13. Reverse procedure to install.
14. Verify operation.
OVEN DOORS AND BEARINGS
Ending at Serial Number 481907145
Disconnect the electrical power to
the machine and follow lockout /
tagout procedures.
1.
Remove the top front cover and bottom front
cover as outlined under Covers and Panels.
2.
Remove the door switch lever.
Fig. 34
3.
Remove the lower door seal strip to expose the
mounting screws of the door assembly.
4.
Remove the two lower sill bolts by the lower door
shaft and the four countersunk screws from the
lower sill.
Fig. 35
SG4 & SG6 Series Full Size Gas Convection Ovens - REMOVAL AND REPLACEMENT OF PARTS
F35626 Rev. B (1118)
Page 18 of 56
