E36LC SERIES ELECTRIC RESTAURANT RANGES - REMOVAL AND REPLACEMENT OF PARTS
F25297 (July 2008)
Page 7 of 28
7.
Remove inside door bolts.
8.
Loosen outside door screws, then slide to inside
of door slot to disengage pins from door
mounts.
9.
Open door partly and remove.
Installation
1.
Reverse removal procedure to install.
NOTE:
Make sure that pins inside door engage
holes in door mounts.
NOTE:
Red oven door hook goes on the right side
and blue hook on the left.
2.
Rotate turnbuckle to tension springs until door
closes on its own when held open 5 inches.
Door should bounce once or not at all.
3.
Check range for proper operation.
DOOR MECHANISM
COMPONENTS
1.
Remove kick panel as outlined under COVERS
AND PANELS.
2.
Pinch a rag in the door to prevent the door from
falling open during procedure.
3.
Loosen nuts while holding "J" hooks from
rotating.
NOTE:
One nut will be right hand threaded and the
other will be left hand threaded.
4.
Rotate turnbuckle to relieve most of the spring
tension.
5.
Remove springs, turnbuckle assembly, and
door hooks.
6.
Remove cotter pins from bell crank pins (behind
bracket).