7
EN
3.2.2. HORIZONTAL ASSEMBLY WITH USING INSTALATION HANDLES.
It is possible to assemble DEFENDER 100-200 do the wall horizontally in two options:
OPTION I:
Assembling handles with their arms faced downwards. In this option you should first screw the installation handles to the
wall (1) and then at regular intervals (for a 1m curtain it is 2 installation hanles every 700mm, for 1.5m – three, 2m - four installation
handles every 600mm) so that the handles' arms are levelled.
Then slide 2 (DR -1m), 3 (DR-1.5m) or 4 (DR-2m) assembly screws (2) M10x20 in each of the two guide bars. Lift the curtain with
the screw faced upwards and assemble them in the handles. Put backing straps (3), tighten the nuts (4) and close the handle's
covers (5).
ATTENTION!
The minimum distance between the unit and the ceiling should be 0.2 m.
2
2
OPTION II:
Assembling handles with their arms faced upwards.
The assembly consists in attaching the installation handles to the unit (1) at regular intervals as in OPTION I In order to do so you should slide 2 (DR -1m), 3 (DR-1.5m) or 4 (DR-2m) assembly screws
(2') M10x80 in each of the two guide bars and knock out holes (6) on the outside of covers (5) with the use of a hammer and a screw and then close the handles' covers (1). Put the handles on the
screws, put backing straps (3) and tighten the nuts (4).
In this assembly option you can first assemble the handles to the curtain and than screw the whole down to a wall.
ATTENTION
! The minimum distance between the unit and the ceiling should be 0.2m.
3
3.2.3. VERTICAL ASSEMBLY DIRECTLY ON THE WALL.
For mounting DEFENDER directly to the wall use the left or right hand side holes (1) (depend on hanging side) on the back of the unit. Fixing screws Ø6 mm thick (not included) should have head
diameter of not more than 14mm.
7
1
IMPORTANT
! In case of vertical assembly the minimal distance between the device and the floor (150mm) for access to the water coil blowdown connection and the cable terminal should be provide.
min. 0,2m