Getting Started
4
Before use
Check for dial tone
Lift the wireless mics from the charging cradles, and then put them on the table.
After that, press
. If you hear a dial tone, and see that the status indicators turns
green on both the base unit and the wireless mics, the installation is successful.
If you do not hear a dial tone:
Make sure the installation procedures described above are properly done.
It may be a wiring problem. If you have changed your telephone service to digital
service from a cable company or a VoIP service provider, the telephone line may
need to be rewired to allow all existing telephone jacks to work. Contact your
cable/VoIP service provider for more information.
Operating range
This conference phone operates with the maximum power allowed by the Federal
Communications Commission (FCC). Even so, this wireless mic and base unit can
communicate over a certain distance, which can vary with the locations of the base
unit and wireless mic, the weather, and the layout of your office.
When the wireless mic is out of range, the status indicator flashes red slowly on the
wireless mic. The wireless mic will sleep after out of range for 30 minutes. Therefore,
you should always return the wireless mic to the charging cradle after use.
If there is an incoming call while the wireless mic is out of range, the incoming call
green light may not flash on the wireless mic. If it flashes, the call may not connect
well when you press on the base unit. Move the wireless mic closer to the base
unit, and then press on the base unit to answer the call. If the wireless mic moves
out of range during a telephone conversation, there may be interference. To improve
reception, move closer to the base unit.
•
•