USING THE TRAMLINER BLADE
The tramliner blade is used for creating accurate detailing, edge
lines and designer tramlines in hair and facial hair.
To attach the interchangeable tramliner blade
, remove the
telescopic comb guide fi rst by adjusting the cutting length to the
shortest setting (3mm for the 3mm – 18mm comb guide and 21mm
for the 21mm – 36mm comb guide). Switch the product off and
then push the comb guide out of the support by lifting it up with
your thumb.
You will need to remove the existing blade from the clipper before
using the tramliner blade. To remove the blade, hold the handle of
the clipper with one hand and place your free hand on top of the
clipper head, with the thumb placed at the back of the blades. Place
your index fi nger and middle fi nger at the front of the blade. Using
your index and middle fi ngers, pull the blade backwards and click
off from the clipper. Place the blade in a secure place.
Attach the tramliner blade by lining up the insert with the lug at
the bottom of the blade. Slant the blades forward and then click
into place.
To remove the tramliner blade
, hold the handle of the clipper with
one hand and place your free hand on top of the clipper head,
with the thumb placed at the back of the tramliner blade. Place
your index fi nger and middle fi nger at the front of the tramliner
blade. Using your index and middle fi ngers, pull the tramliner blade
backwards and click off from the clipper. Place the tramliner blade
in a secure place.
Attach the standard blade by lining up the insert with the lug at
the bottom of the blade. Slant the blades forward and then click
into place.
STARTING AND USING THE CLIPPER
NB –
Use on clean, dry hair that is combed until tangle free.
1. Select the correct comb for your desired cutting length.
2. Push the on/off button to activate the clipper. The ‘I’ symbol will
be shown on the on/off button to indicate that the product is
switched on.
3. Turning the grooved rotary wheel up or down to position the
comb guide to the desired cutting length. It is always suggested
to start cutting with the longer length fi rst, then cut again if the
length is longer than desired.
4. Hold the clipper against the hair, the teeth of
the comb guide should be pointing upwards
and fl at against the head.
5. Move the clipper upwards and outwards through
the hair, a little at a time, against the direction
of hair growth. (Fig 1)
6. The clipper will work most effi ciently when
cutting through the hair at its own speed. Never force through
the hair.
7. Never switch the clipper off whilst in the hair.
8. For longer hair on top of your head, you may wish to use the
barbers comb to lift the hair and then clip over the comb, or hold
the hair between your fi ngers and cut to the desired length.
• For the finishing touches, that is, around the
nape and sideburns, use the clipper without a
comb guide. Turn your clipper over and move it
from top to bottom. (Fig 2)
• If you want a length greater than 36mm, or if you
are experienced, you can create ‘comb’ and ‘finger’
cuts:
- Take up a small section of hair with a comb or in your fingers.
- Move the comb or your fingers along the section of hair to the
desired length.
- Cut your hair along the comb or your fingers.
Fig 1
Fig 2
VS7702A-IB.indd 12-13
VS7702A-IB.indd 12-13
4/2/09 4:13:54 PM
4/2/09 4:13:54 PM
