Cut away the covering inside
before install the air scoop
6x40 nylon
bolt
ABS air scoop
CA
Sticker
Wing bolt block
Plastic air scoop
6x40 nylon bolt
(Ply wood)
Plastic mount nut
WING
10-
12mm
15/32
6.5mm
1/4
11-
Using the ABS air scoop as a template,
trace around the outside edge of the
air scoop and then remove it.
Using a sharp hobby knife, cut away the
covering inside the lines. Not to cut into
the wood.
Apply the ABS air scoop in place and
secure with CA glue.
Make holes for wing bolt
12-
SIDE-VIEW
A
A’
B
B’
A=A’
B=B’
TOP-VIEW
Fire wall
! Engine thrust on balk head
is already adjust at factory
Using a aluminum motor mounting plate as
a template, mark the plywood motor mounting
plate where the four holes are to be drilled (2).
Remove the aluminum motor mounting
plate and drill a 1/8”(3mm) hole through
the plywood at each of the four marks
marked .
CA
1
3mm
2
Note: The aluminum motor mounting included
with electric motor set.
Air scoop installation / Ohlkuler Attrappe
Wing / Tragflache
Brushless Motor
110 - 112mm
