107 mm(4.2”)
Wing center section
DO NOT try to fly an out-of-balance model !
RUDDER STROKE
ELEVATOR STROKE
AILERON STROKE
The recommended C.G (Center of Gravity) location for the Macchi is
106 - 108mm (~4.2”). Adjust the location of the battery pack as required to
achieve this C.G location.
1/4”(~6mm)
1/4”(~6mm)
3/8” (~10mm)
3/8” (~10mm)
1 (35 mm)
3/16”
1 (35 mm)
3/16”
28- Balance / Schwerpunkt
26- Control surface
Ruderausschlage
27- Decor / Aufkleber
Note: Cut out the stickers and apply them in the proper area. Do not peel the backing paper off all at once.
Peel off one corner of the backing and cut off with scissors.
Arrange sticker on model and when satisfied adhere the corner without backing.
Carefully peel back the rest of the backing while at the same time adhering the rest of the sticker.
Try not to make air bubbles, if there are some, carefully puncture sticker (center of bubble) but not model surface with the tip of the
knife or sharp pin and squeeze out the air. At curves stretch sticker and apply a little heat so that no ceases occur. Cut off the excess
that is produced.
QUERRUDER
SEITENRUDER
HÖHENRUDER
IMPORTANT:
Please do not clean your model with strong solvent or pure alcohol, only use liquid soap with water or glass cleaner
to clean on surface of your model to keep the colour not fade.
CENTAURO
SERIE 1
MM 95077
CENTAURO
SERIE 1
MM 95077
4
S
T
O
R
M
O
O
C
A
I
C
C
A
4
S
T
O
R
M
O
O
C
A
I
C
C
A
FIAT G.59 VQ MODEL
4
S
T
O
R
M
O
O
C
A
I
C
C
A
OR
