Vortice VORT HR 300 NETI, Инструкция пользователя

Страница: 23 / 116

23
• Switch off the main switch on the system when: a
malfunction is detected, you decide to perform external
cleaning maintenance, you decide not to use the device for
short or long periods.
• The device cannot be used as an activator for water heaters,
stoves, etc. nor should it discharge into the hot air ducts of
said devices.
• The device must discharge directly outside in a single
allocated duct.
• The extracted air flow must be clean (or rather free of
grease, soot, chemical and corrosive substances or
explosive and flammable mixtures).
• Never cover the device exhaust and supply to ensure
optimal
air passage.
• Maximum operating temperature: 45°C.
• The electrical specifications correspond to the ones on the
data label A (fig.1).
• I dati elettrici della rete devono corrispondere a quelli
riportati in targa A (fig.1).
Structure and equipment
The main components of the device are:
• An external body composed of a polypropylene foam shell
and a front cover panel
• A polystyrene counter cross flow heat exchanger, whose
particular morphology guarantees a very high heat
exchange efficiency (>85%)
• Two brushless, low consumption motors with two pre-set
operating speeds
• Management electronics which oversee the power supply
and command and control of the device:
• Temperature sensors (bypass and defrosting)
• User panel, located on the front panel of the device
• Remote panel (optional)
• Two filters: G4 and M5
Meaning of the air vents (fig.2)
A: Clean air supply toward inside
B: Stale air exhaust from inside
C: Fresh air exhaust from outside
D: Stale air supply toward outside
1 1
A
2 2
A
B
C
D
ENGLISH