Vortice HRI MINI EP, Инструкция пользователя

Страница: 22 / 44

22
ENGLISH
INFORMATIONS ABOUT THE MODEL
The device you purchased might show up in two different configurations (Model 1 and Model 2), with similar
performances. In the following the differences between the two models are described
Model 1 (see figures above)
- no filters and inspection covers
- different start-up procedure (installer), that must be done as follows:
• there is no “installer mode”
• Isolate the appliance from the power supply for 5 seconds, then reconnect.
• To activate “installer” mode, which allows the user to set the speed of the fans, turn potentiometer RV2 first
anticlockwise to the travel limit, then turn clockwise, and finally turn anticlockwise again. At the end of this sequence,
the red Led on the circuit board will blink at one-second intervals. Once 120 s have elapsed after activating “installer”
mode without any changes being made to the factory-set fan speeds, “installer” mode will be deactivated automatically.
• Settings: see chapter “Commissioning”, the same in both models.
• Once the flow rate values indicated in the project specification have been set, disconnect the appliance from the
power supply for 5 s, then reconnect. The red Led will cease blinking and the speeds set with the potentiometers will
be saved in the permanent memory of the appliance.
All other machine control procedures are identical to those of Model 2, described below.
Model 2 (see figures above)
It is described as follows in this document.
Model 1
Model 2
MORSETTIERA
DIP SWITCH
RV1
RV2
VENTILATORE
IMMISSIONE
ARIA PULITA
MORSETTIERA
LED ROSSO
LAMPEGG.
VENTILATORE
ESPULSIONE
ARIA VIZIATA
MORSETTIERA
DIP SWITCH
RV1
RV2
VENTILATORE
IMMISSIONE
ARIA PULITA
MORSETTIERA
LED ROSSO
LAMPEGG.
VENTILATORE
ESPULSIONE
ARIA VIZIATA
INSTALLER MODE
SWITCH
FILTERS