Vortice HRI MINI EP, Инструкция пользователя

Страница: 34 / 44

34
SWITCH POSITION AUTO
1 2 BY-PASS
SWITCH POSITION % OF FULL SPEED % OF FULL SPEED
% OF FULL SPEED SWITCH LIVE NOT ACTIVATED
EXTRACT 10-35% 13-53% 53-99% Extract Fan Returns to Commissioning Speed
SUPPLY 10-35% 13-53%
53-99% Supply Fan Runs at Switch Position 2 Speed
SWITCH LIVE ACTIVATED
EXTRACT BOOST
SWITCH LIVE
30-98%
Returns to
Commissioning
Speed
Returns to
Commissioning Speed
Extract Fan Returns to Commissioning Speed
SUPPLY BOOST
SWITCH LVE
30-98%
Returns to
Commissioning
Speed
Returns to
Commissioning Speed
Supply Fan Returns to Commissioning Speed
NOTES
GENERAL
Commissioning
Speed Set in
Installer Mode
Both Supply and
Track Together at
Set Speed
Both Supply and
Extract Track
Together at Set
Speed
In By-pass mode the supply air fan runs at the speed set
at switch posistion 2 with the Extract fsn running at te
speed set at position Auto. When switch live has been
activated both fans return to the commissioning speed.
ENGLISH
WATER DETECTION IN CONDENSE TRAY
If the condensation build up is unable to flow out of the drain pipe and the water rises above a predetermined level it
will be detected by the sensors in the condense tray and the red LED will flash every 3 seconds until the condense tray
is drained.
The fans will stop to prevent any further water to build up.
The LED will revert back to flashing every second after water level has dropped below predetermined level the fans will
restart.
If condition persists, investigate the cause and rectify.
HANDING
This unit is delivered configured for right hand configuration.
THERMAL BY-PASS
The thermal by-pass is manually operated by turning the remote users control to By-pass position. In By-pass mode
the supply air flow rate increases and the extract flow rate decreases lowering the thermal heat recovery through the
heat exchanger, lowering the supply air temperature.