© Rototilt Group AB
2018-03-16
Right
Left
B
2
A
1
Control Unit -
Excavator
C
D
EN
English
Handle
The handles are equipped with switches
and rollers to control Rototilt® functions
and base machine functions.
The standard version has 2 rollers and 7
switches in each handle.
There are 5 switches for the base
machine functions.
The handle functions are configured by
an authorised installer. Functions are
programmed according to the following
standard unless otherwise stated.
Left Handle
A Rotation
1 Option 1
D Extra 2
Right Handle
B Tilt
2 Option 2
C Extra/Grapple
Also see sticker and display
!
IMPORTANT
- The base machine’s factor-installed
handles have been replaced with handles adapted
for ICS.
Carefully check the changed functions, for both the
base machine and Rototilt®.
Machine control
Machine control regulates the oil flow to
the hydraulic circuit for extra equipment
on the base machine. Movement of
the rollers in the handles affects the oil
flow in the machine's main valve via the
control unit.
The system has two different functions:
Rototilt® control
When the 8-pole connector on the stick is
connected, a flow is regulated parallel to
the valves on Rototilt ® and the hydraulic
flow is adjusted to this.
The flow runs in one direction only.
Regulation of extra hydraulics
When the base machine is run without
Rototilt ®, the control can be used to
regulate the oil flow in the machine circuit
for extra hydraulics.
The flow can be regulated in both
directions.
2200397_ _6909