Volvo EC15E, Руководство оператора

Страница: 73 / 238

The cab is designed to meet the requirements for
falling objects, the weight of which agrees with
testing methods according to ROPS-standard
(Roll Over Protective Structure), OPGstandard
(Operator Protective Structure) and TOPS (Tip-
Over Protective Structure), see page 10 .
During electrical storms, do not enter or exit the
machine.
- If you are off the machine, stay well away from
the machine until the electrical storm passes.
- If you are in the cab, remain seated with the
machine stationary until the electrical storm
passes. Do not touch controls or anything
metal.
Always wear approved respirator for the materials
being used.
When travelling on, for example, very rough and
uneven ground, the operator may be thrown
about and contact with the windshield is possible.
Reduce this potential hazard by travelling at low
speed and be extra careful under these
conditions. Also wear a hard hat.
Stability when working
The stability of the machine is subjected to
considerable changes. The operator himself must
observe all special regulations applicable to every
operation in order to obtain full working safety.
NOTICE
Risk of machine damage!
Improper use could cause serious machine
damage.
Never anchor or fix the undercarriage to the ground
or any object when digging or lifting.
NOTE!
A pre requisite for good stability is that the machine
is parked on level ground of sufficient load bearing
capacity. Care should be taken if the ground is soft
and uneven, sloped, in danger of collapsing, side
stress and other dangerous situations.
Operating on public roads
Road signs, traffic restricting arrangements and
other safety devices, which may be required
Operating instructions
Safety rules when operating 71