2 Open the rear hood.
3 Pull out the dipstick and wipe it clean with a lint-
free cloth, reinsert it until it bottoms and pull it
back out.
4 The oil level should reach the upper mark (MAX).
5 If the oil level is near or even below the bottom
mark (MIN), top up oil immediately through the
oil filler (1) to avoid severe engine damage. Don’t
fill over upper mark (MAX)! For quality of oil refer
to the table of fuels and lubricants, page
179
).
Water separator, checking and
draining
Water separator, checking
1 Open the rear hood.
2 Check the sight glass of the water separator for
water and dirt accumulations.
3 If the water level is over or near the drain water
mark (1) or dirt accumulations can be seen, the
water separator must be drained and cleaned.
Water separator, draining and cleaning
1 Close the fuel valve (2) by turning it
counterclockwise to position C.
2 Place a suitable collecting vessel underneath
the water separator.
3 Release the swivel nut (4) and remove the sight
glass (3).
4 Drain the content into the collecting vessel.
NOTE!
Do the work in an environmentally safe manner.
5 Clean the sight glass (3) and install it again with
the swivel nut (4).
6 Open the fuel valve (2) by turning it clockwise to
position O.
V1150449
1
1
V1151718
2
3
4
V1151100
C
O
Maintenance
Maintenance service, every 10 hours
159
Содержание EC15E
