Volvo 2016 XC 90 Twin Engine, Руководство пользователя

Страница: 211 / 582

LOADING AND STORAGE
}}
* Option/accessory, for more information, see Introduction. 209
CAUTION
Pressure from the front seats against the
cargo net could damage the net and/or its
brackets.
5. Pull the lower straps taut.
Removing and storing
1. Reduce tension on the net by pressing the
button on the lower straps' respective locks
and allow some slack on both sides.
2. Press in the catches and release both of the
straps' hooks.
3. Remove the upper hooks from the ceiling
mounting points.
4. Press the red button on the upper rod to
allow it to fold.
5. Fold and roll up the net.
Store the net under the cargo compartment floor.
Related information
•
Cargo compartment cover
*
(p. 211)
•
Load anchoring eyelets (p. 210)
•
Steel cargo grid
*
(p. 209)
•
Loading (p. 205)
Steel cargo grid
*
Your vehicle can be equipped with a steel grid
that helps prevent objects in the cargo area from
moving forward into the passenger compart-
ment.
The steel grid is made up of the grid itself and
two separate mounting brackets. Each of the
brackets has a screw cover and there are two
plastic sleeves for the grid.
WARNING
•
No one should ever be allowed to remain
in the cargo compartment when the vehi-
cle is moving.
•
The steel grid may only be used in the
rear position described in this article. The
ceiling attachment points above the front
seats are
not
intended to anchor the
steel grid.
•
The third row of seats (7-seat models
*
only): these seats must be folded down
when the steel grid is mounted in the
vehicle.
•
After being mounted, be sure that the
steel grid is securely anchored in place.
Mounting
1. Fold down the rear seats (second row of
seats in 7-seat models) and lift in the steel
grid through one of the rear doors or the tail-
gate. The curved (convex) side of the grid
should face toward the cargo compartment
and the hooks on each side of the grid
should face upward. The mounting brackets
and plastic sleeves are not needed in this
step.
2. Press one of the grid's hooks into the larger
part of the opening in the ceiling attachment
point (1) as shown in the illustration.
3. Grasp the grid near the hook and move it
toward the smaller opening (2).
> This secures the hook in the attachment
point.
4. Repeat steps 2 and 3 for the hook on the
opposite side of the grid.