9
10. Inserting and removing the memory card
The measuring instrument allows thermal images to be stored on a removable microSD memory card. This makes it
is possible to easily exchange data and further process image data on a computer.
microSD cards of up to 16 GB can be used.
To insert/replace the memory card, proceed as follows:
• Open the rubber cover (6) on the top of the device.
• The memory card slot is on the left. The symbol for the correct position of the memory
card is indicated. The memory card contacts must face the display.
• Gently push the memory card into the slot until it clicks into place. Ensure that the memo-
ry card engages in the slot. This is the only way of ensuring reliable storage.
• To remove the memory card, briefly press on the card until it is unlocked and pushed up
slightly. You can then easily remove the card.
• Carefully close the rubber cover to ensure protection against moisture and dust.
If the memory card is not recognised when triggering memory with the red trigger button (9) for
image storage (card symbol with a red X on the display), check the memory capacity, the correct fit
or the correct data formatting (FAT32) of the memory card.
11. Setup
a) Turning the camera on and off
• Use the red on/off button (3) to turn the camera on and off.
• To turn the camera on, press and hold down the red on/off button on the keypad below the display for approx. two
seconds.
• The camera will turn on and display the “VOLTCRAFT” start screen for approx. four seconds. The image sensor will
be calibrated at the same time. This is indicated by a quiet clicking sound.
• Once the automatic calibration is completed, the currently captured thermal image is displayed.
• To turn the camera off, press and hold down the red on/off button on the keypad below the display for approx. two
seconds. The device turns off.
